Electronics > Beginners

driving two LMZ14201 by using LM3880 with Mosfet

(1/1)

BeO:
Hello

I need to drive two LMZ14201 in sequence

I will try to test this schematic updated with two Mosfet to drive the EN pin and one p Chanel to put the EN pin to the ground

P Mosfet  will ground through a resistor to force LMZ14201 to 0 V output

N Mosfet will power the EN pin to 5 V

and vise versa following flag level ( flag is in 5 V )

can someone can give an advice on this schematic

I will set one circuit per LMZ14201

Regards

BeO

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod