Electronics > Beginners

Dual 555 Timer (with inverted signal) for H Bridge Problem

(1/2) > >>

z7d8tsg:
Dual 555 Timer (with inverted signal) for H Bridge Problem

I tried this circuit but it doesn't work. Any thoughts?

Thanks,

- Dan

David Cutcher CEG:
You say "H Bridge problem." 
You need to be more specific.
What is the problem? 
Is this a problem for school?
What is the expected output?
Not enough information here for me to attempt a helpful answer.

David Cutcher "Certified Evil Genius"

z7d8tsg:
im building an h bridge that uses 2x 555 timer with optocoupler non zero gate crossing (k3011p). It needs to run off of 1x power supply at the end, I will be using voltage regulators to regulate voltage and resistors to split amperes properly. Is for a high accuracy remote car

Best,
- Dan

David Cutcher CEG:
The original circuit, attached, should work. I'm uncertain about where your added lines are connected.
Also, as noted on the circuit, this is using a split voltage. You don't indicate that on yours.
David Cutcher "Certified Evil Genius"

soldar:
That circuit could have some serious shoot-through problems.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod