EEVblog® Electronics Community Forum
Electronics => Beginners => Topic started by: blackbelt5 on June 14, 2026, 11:10:15 pm
-
trying to fine the eeprom in this board. everything is cover with some kind of material. any help is appreciated.
-
normally eeproms are never far from any major mcu package / physical size ... check all 8 pins soic devices around "the big one"
for the coating is it hard, sometime acetone may get thru it
is it soft, sometimes scraping the board, say with wooden tooth pick or anything non metallic to prevent scratch
but you should go in automotive forums
you dont give us nothing to work with
-
My bet would be here.
-
trying to fine the eeprom in this board. everything is cover with some kind of material. any help is appreciated.
You have internal flash plus internal EEPROM emulation within MCU.
[attachimg=1]
This is very common on modern ECU's. If it's something like Renesas, Infineon, ST, NXP, etc., this is likely the case.
You can also have EEPROM inside a CAN/LIN transceiver or ASIC. Some custom ASICs store calibration data internally.
You need to remove that conformal coating off MCU so we can read what it is. Is it silicone gel? Use heat gun at 100C or so and scrape using plastic or wooden scraper, RELIFE carbon fiber opening tool is great for this. Gently wipe with IPA try not to wipe off chip markings. If it's urethane, use MG Chemicals 8309 Conformal Coating Remover Pen or MG Chemicals 8310A Urethane Remover, apply to chip and let it sit 5 to 10 minutes.
-
My bet would be here.
Me don't thinky that way. That thing looks like an op‑amp, or LIN/CAN transceiver, or voltage monitor, or a gate driver. Surrounding passives don’t match any serial EEPROM family. :-//