| Electronics > Beginners |
| Electrical load for R&R study on safty and function tester |
| (1/1) |
| DanielP:
Hy, I am newbie in this forum, looking for a few hints related my new project. I found the introduction of those forum really cool, that is why i writing my question here: I am going to do Gage R&R study on universal safety- & function testers During the studies, I would like to check the tester these 3 functions: - ground bond resistance measuring - 2.0 Ohm at 30A - insulation resistance measuring - 2.0 Ohm at 500V DC - funkcion test, current measuring, 1.0 sec./ measuring 30 ok and 30 nok measuring per funkcion for the R&R For this my plan to build a constant load simulating a LED luminaire, with datas: - nominal voltage: 230V - power: 34.0 W - Apparent power: 35.6 W - Cos phi (power factor): 0.96 - constant resistances for ground bond resistance and insulation resistance measuring Can someone help me, where can I found infromations, examples or advices about using long term stabil loads for calibration or R&R? in the ranges mentioned above? Tester: Schleich GLP2 (https://www.schleich.com/en/produkt.php?ProduktID=185) Thanks a lot for the help, br: Dani. |
| Navigation |
| Message Index |