Electronics > Beginners

EMI design tips

(1/1)

Wartex:
http://www.hottconsultants.com/techtips/maxemission.html

ivan747:

--- Quote from: Wartex on June 28, 2011, 02:12:05 am ---http://www.hottconsultants.com/techtips/maxemission.html

--- End quote ---

That's always handy. I have been using this one for digital circuits:
http://focus.ti.com/lit/an/szza009/szza009.pdf

ivan747:
By the way, this would be more useful if it where on the general chat forum or the EDA forum
.
*Could any moderator move this, please?*
 It would be more convenient since beginners usually don't require this kind of techniques until they get into really design-critical stuff. Also, more people visit the General chat section.

Ivan

Neilm:

--- Quote from: ivan747 on June 28, 2011, 02:47:25 am ---
That's always handy. I have been using this one for digital circuits:
http://focus.ti.com/lit/an/szza009/szza009.pdf

--- End quote ---

Note that that is over 10 years old. Some EMI thinking has changed over that time due to die shrinkage so I would always check by looking at new publications. I tend to look at http://www.compliance-club.com/ and read the articles by Keith Armstrong. Following these tips has worked for me.

Neil

ivan747:

--- Quote from: Neilm on June 28, 2011, 06:35:18 pm ---
--- Quote from: ivan747 on June 28, 2011, 02:47:25 am ---
That's always handy. I have been using this one for digital circuits:
http://focus.ti.com/lit/an/szza009/szza009.pdf

--- End quote ---

Note that that is over 10 years old. Some EMI thinking has changed over that time due to die shrinkage so I would always check by looking at new publications. I tend to look at http://www.compliance-club.com/ and read the articles by Keith Armstrong. Following these tips has worked for me.

Neil

--- End quote ---

My mind still tells me that if the year starts with 2, is new. Welcome to the new millennium!

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod