Electronics > Beginners
Few questions about Rigol1054 use.
(1/1)
Tomer:
Hello All and thank you for your help.

I have 3 questions about Rigol1054 use that i can't find answers, i went over the manual few times with no luck
* Please see attached pic.

1) Is there a way to display only a specific measurement, for example the VPP. I can only choose between display all or none ?
2) Can I clear that line or decide what will be the default readings for display ?. I find myself need to change it again and again to what i want.
3) How to stop that from being displayed  ?

Thank you for your help
Tom
mcinque:
1) to show only a specific measurement use the left menu, choosing the measurement you want on the screen, this measurement will be "added" to the bottom bar on the screen; depending on the font size, you can have 4 or less measurements at the same time on the screen

2) you can clear the line with the right menu "clear"

3) if I understood correctly, you want to remove "measure all": you can do it using the right menu and pushing on "measure all"

I suggest to watch some YouTube reviews and you will understand quickly many menu commands and functions of the scope.

Hope it helps
Tomer:
Thank you for your help!

Tom
metrologist:
this is a more clunky part of the interface so not surprised it's not intuitive.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod