Electronics > Beginners
First pcb
<< < (4/8) > >>
Tom10000:
So like what I attached down below would that be correct

thanks for pointing it out
ataradov:
Yep. That looks correct. The resistor part, I have not checked the rest of the components, but general schematic looks correct, and the values can be tweaked later.
Tom10000:
Okay, I moved the capacitors over and fixed up PR1

Thanks
ataradov:
Your logo still has that thin circle outline. It will disappear in manufacturing.

Also, if you plan to put some connectors on the input and output pins, then silk screen text will be obscured by those connectors. If they are just for soldering wires, then it is fine.

Text with the date is also too small, it will be a smudge at bets and will not be printed at all at worst. Silk screen has pretty bad resolution from cheap PCB manufacturers. And there is plenty of space, no need to go small.
Tom10000:
Okay Increased the line width and the labels are just or soldering wires so they are fine how they thanks
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod