Electronics > Beginners
First time merging gerbers and using 'Panelizer'
(1/1)
timgiles:
Hi,

I was hoping someone could run their eye over the attached gerbers. Its the first time I have used 'This is not rocket science' - gerger panelizer to merge two designs in to a panel - and add break off tabs. Split in to two zips to keep within 1Mb / file limit.

Thanks in advance

Timothy
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod