EEVblog Electronics Community Forum

Electronics => Beginners => Topic started by: balavinayagambt on September 06, 2017, 05:27:49 am

Title: FPGA programming
Post by: balavinayagambt on September 06, 2017, 05:27:49 am

Hi!!!
I am using the Lattice iCE40 ultraplus mobile development platform and I encountered a problem while programming it.
The error is :
ERROR-Failed to scan board.
ERROR-Scan Failed - Creating Blank Programmer Project.

I am using Lattice diamond programmer 3.9 in Windows 10 and UWG30 package in the iCE40Ultraplus MDP.
Can anybody give some suggestion or idea to solve it?
Expecting a solution soon...

Title: Re: FPGA programming
Post by: Ammar on September 06, 2017, 09:26:00 am

Hello,

A picture of your set up would be helpful.