Author Topic: FTP410  (Read 124 times)

0 Members and 1 Guest are viewing this topic.

Offline iRGUY

  • Newbie
  • Posts: 2
  • Country: us
« on: April 22, 2021, 06:52:31 pm »
Trying to find out why i cannot see the tX outputs or CLK signals from the chip on my digital scope when the chip is connected to a monitor thru an HDMI port. I only see 1.8 high levels on each output due probably to the pull-up resistors from the monitor. I tried observing these same outputs from a Gumstix Summit board connected to a display the same way and it had a picture on it but again all I could see when I monitor the lines are 1.8V levels. How can I view the signals?

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo