Electronics > Beginners
Function of a little dot on bobbin of a flyback transformer
(1/1)
khatus:
Hello guys i want to know function of this dot on bobbin of a flyback transformer.I guess it is for dot convention of transformer



when i remove first layer of sticky tape i have found it was wound in clockwise direction.




Domagoj T:
Marking for pin 1.
Ian.M:
It wouldn't need a peg like that just to visually *identify* pin 1, so it must be intended to operate a sensor or engage with a hole in a jig for (semi) automated assembly to ensure the bobbin orientation is correct with respect to the coil winding machine, or for part orientation during (semi) automated board stuffing.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod