Electronics > Beginners

Getting confused with the basics and using my power supply

<< < (6/6)

tooki:

--- Quote from: HwAoRrDk on February 05, 2020, 07:52:13 pm ---The current readout on these Tenma (aka Korad) power supplies isn't very accurate below 10 mA. I have one too and it's the same. In a case like this, trust your meter rather than the PSU.

--- End quote ---
Somewhere, I found instructions for how to calibrate it. I was able to get it a bit better than the factory calibration by calibrating it against a decent DMM.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod