Electronics > Beginners

Hameg HM605 Ready To Go

(1/2) > >>

JCEEVBLOG:
Hi all

I have cleaned up the entire fascia (looks like new) remove all dust from outside/in. I have cleaned all the pots and switches and put it back together.

Switched it on and all is well. I don't have any probes yet they arrive tomorrow so here's a question for you.

Whats the first things I should do when I get my probes to test the scope or calibrate things?

Regards

CJay:
Check the 'scope works, that it trigger, that you can compensate the probes, get used to using it.

 

JCEEVBLOG:
That you can compensate the probes?
Is that the same as attaching them to the test point on the scope?

I will get googling as this is all new to me :-)

CJay:
Honestly?

The best thing you can do is read the manual, Hameg do good manuals with lots of info in them.

Probe compensation is adjusting the probes so the 'scope displays a square wave from the test point on the front of the 'scoope.
 

JCEEVBLOG:
Yes I read that in the manual before I saw your post so appreciate your comment.

Am on the case and regards the start of your post 'honestly' this is all new to me 100% as I am sure you wouldn't know where to start regards setting up a new Windows domain with Exchange/SharePoint and SQL servers etc.etc.!!

Regards

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod