Electronics > Beginners
Heavy duty AC to DC converter required
<< < (13/13)
oldway:
Choosing a max voltage of 56V, your new electrolyser must have 20 cells and need a current of 66A to produce the same amount of Brown's gas as your actual 300V / 12A electrolyser.

Try to stay with a low density current of 0.2A / cm² (electrodes of 330 cm² - 27.5 x 12 cm²)
mche1997:
Great, lots of ideas now and I will start hunting, thank you all guys.
schmitt trigger:
The only advise that I would give you with respect to used cell tower PSUs, is to open them up and thoroughly clean them inside.
And I mean thoroughly.
You will not only find dust and dirt, but the occasional life form which was attracted by the warmth and decided to crawl inside, only to be duly shocked.

I know. I used to work at a place where we built and refurbished Telecom supplies. I wish I still had the picture of a power rack, which had been installed somewhere in India, which had a thick snake, almost 5 feet long, completely fried.
Small rodents are quite common.
mche1997:
Oh, that is scary, thanks pal
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod