Electronics > Beginners
Help identify IC
giosif:
Hi,
Once again, I am in need of help identifying the IC in the below picture.
Two such components are found in the input section of a bench meter (Gossen Metratop 52) and I'm trying to figure out what they're supposed to do.
Thank you!
andy3055:
May be this?
https://pdf1.alldatasheet.com/datasheet-pdf/view/6768/NEC/UPC4556G2.html
There is a link for the data sheet on that page. Not sure if it is the one.
Jwillis:
I was thinking it's a dual mosfet like https://www.onsemi.com/pub/Collateral/NTMD4840N-D.PDF because of pins 2 and 4 could be gates 5 to 8 look like they are on the same wide trace .Could be drain ?
giosif:
Thank you both for looking into this!
I too think it is likely a mosfet, but I'll try to confirm.
andy3055:
Try to trace the pin out/nearby circuitry and then you will get a better idea of what it should be.
Navigation
[0] Message Index
[#] Next page
Go to full version