Electronics > Beginners

Hooked audio amplifier to my scope and amp died

<< < (2/2)

ghinckley68:
yeap it was running in BTL

ghinckley68:
I have 50watt test load. those Al block not inductive loads

ghinckley68:
So hook one probe to the negative and one to the positive? a

supperman:

--- Quote from: ghinckley68 on February 02, 2020, 02:57:01 am ---So hook one probe to the negative and one to the positive? a

--- End quote ---

yes, and you can see if there is a ground (or use the case) for the ground on both.

Then go to the math function to combine them into one signal if you want to actual values.. or just know what you are looking at when you see the two waves.. since they should just be mirrored / opposite.

ghinckley68:
thanks i have a few throw aways to practice with

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod