Electronics > Beginners
How do I build a PCB from schematic?
(1/1)
redgear:
I followed few open source projects and duplicated their schematics  on KiCad. How do I build PCBs from this? How to decide the wire thickness, amount of copper, etc?

Thanks
Nusa:




If you want something Kicad specific, there are a ton of tutorial videos. Just a matter of searching for them.

That should give you some general answers. Lots of stuff you just learn by experience. If you later have a specific question you can't find the answer to, ask again.
thinkfat:

--- Quote from: Nusa on August 05, 2019, 07:28:52 am ---If you want something Kicad specific, there are a ton of tutorial videos. Just a matter of searching for them.

--- End quote ---



Covers KiCad 4, but not much difference with 5.
redgear:

--- Quote from: Nusa on August 05, 2019, 07:28:52 am ---If you want something Kicad specific, there are a ton of tutorial videos. Just a matter of searching for them.

That should give you some general answers. Lots of stuff you just learn by experience. If you later have a specific question you can't find the answer to, ask again.

--- End quote ---
Sure. Thanks


--- Quote from: thinkfat on August 05, 2019, 07:53:15 am ---Covers KiCad 4, but not much difference with 5.

--- End quote ---

Thanks
JustMeHere:
Oshpark.com is a good start.

Pcbway is a bit more complicated, but if you keep your design small, it's very cheap.  100mmx100mm.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod