Electronics > Beginners

How do I build a PCB from schematic?

(1/1)

redgear:
I followed few open source projects and duplicated their schematics  on KiCad. How do I build PCBs from this? How to decide the wire thickness, amount of copper, etc?

Thanks

Nusa:




If you want something Kicad specific, there are a ton of tutorial videos. Just a matter of searching for them.

That should give you some general answers. Lots of stuff you just learn by experience. If you later have a specific question you can't find the answer to, ask again.

thinkfat:

--- Quote from: Nusa on August 05, 2019, 07:28:52 am ---If you want something Kicad specific, there are a ton of tutorial videos. Just a matter of searching for them.

--- End quote ---



Covers KiCad 4, but not much difference with 5.

redgear:

--- Quote from: Nusa on August 05, 2019, 07:28:52 am ---If you want something Kicad specific, there are a ton of tutorial videos. Just a matter of searching for them.

That should give you some general answers. Lots of stuff you just learn by experience. If you later have a specific question you can't find the answer to, ask again.

--- End quote ---
Sure. Thanks


--- Quote from: thinkfat on August 05, 2019, 07:53:15 am ---Covers KiCad 4, but not much difference with 5.

--- End quote ---

Thanks

JustMeHere:
Oshpark.com is a good start.

Pcbway is a bit more complicated, but if you keep your design small, it's very cheap.  100mmx100mm.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod