Electronics > Beginners

How do I turn on X-Y mode on analog scope ?

(1/1)

lordvader88:
I know how to do it my on DSO, but not my analog Tek2215
https://www.tek.com/manual/2215-instruction-manual
I don't see it in the manual either.

Also do I hook up the common leads as well for in X-Y mode in general ?? I never played around with it. I have 2 little function generators, I should try them as X-Y

golden_labels:
The SEC/DIV knob. Page 2-5.

lordvader88:
Oh I see it, thanks

Brumby:

--- Quote from: lordvader88 on June 17, 2019, 05:35:35 pm ---Also do I hook up the common leads as well for in X-Y mode in general ??
--- End quote ---
Just treat the two inputs the same as you would for normal 2 trace operation - common ground for all channels.


--- Quote ---I never played around with it. I have 2 little function generators, I should try them as X-Y

--- End quote ---
You can have hours of fun with Lissajous figures checking out frequency and phase relationships - but there's a lot more you can do.

Gyro:

--- Quote from: Brumby on June 18, 2019, 04:11:35 am ---You can have hours of fun with Lissajous figures checking out frequency and phase relationships - but there's a lot more you can do.

--- End quote ---

You can have some fun with chaotic circuits for a start :)  https://docs.jeelabs.org/projects/chaos/

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod