Electronics > Beginners

How do RC car/plane "servo motors" act as servos with only three leads and two w

<< < (4/4)

beanflying:
Just for a little visual of the guts of a fairly recent JR507 servo. From the geartrain side you can see the motor at one end and then the pin on the near side gear goes through the case to the pot on the board to sense direction on the output shaft.

I still have a couple of pre IC servos and if I can find them so I will add them here too.

EDIT No Servo found but here is probably my first Receiver with an actual 'IC' in it. I don't think I have any of the older ones left.  ;D

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod