Electronics > Beginners
How small can you go?
kt315:
Hi,
I've made a few boards with SMD components using toner transfer. Worked quite well for me.
I've got a few interesting parts I am willing to fry, unfortunately they came in MSOP package...
How feasible is it to create a board with toner transfer for MSOP?
Any useful tips?
Thanks.
c4757p:
0.65mm pitch? Absolutely. Just pay special attention to that area when you're transferring.
I wouldn't go much smaller though. I've done 0.5mm-pitch packages before but it was a bit tricky.
kt315:
Yep, they are .65s. I've read at some forum (do not remember which one), that for MSOP solder mask is a must. Is it?
c4757p:
Only for reflow soldering.
kt315:
Ok, thanks a bunch.
Navigation
[0] Message Index
[#] Next page
Go to full version