Electronics > Beginners
How to add soft-start feature to a PSU?
<< < (11/13) > >>
TheHolyHorse:

--- Quote from: Arjunan M R on June 23, 2019, 12:30:22 pm ---
--- Quote from: TheHolyHorse on June 23, 2019, 12:06:38 pm ---
--- Quote from: Arjunan M R on June 23, 2019, 12:00:02 pm ---Here is mine.

--- End quote ---

BTW if you're making your own symbols and footprints save them in a project specific library and include that library with the project files. RN some symbols are missing.

--- End quote ---
Sorry.I didn't save it into project specific library.What can I do.
Are you having problems with footprints.

--- End quote ---

Not the footprints only library symbols not showing up.
Arjunan M R:
 After looking at your  schematic it turns out that you are doing I limiting as i am doing :-//
TheHolyHorse:
Yes
Arjunan M R:

--- Quote from: TheHolyHorse on June 23, 2019, 11:31:42 am ---
--- Quote from: Arjunan M R on June 23, 2019, 11:22:37 am --- Then what is the best way to add current limiting?

--- End quote ---

Mine is just using some mosfet as pass transistor. It's basically doing what the voltage regulator is doing internally.

--- End quote ---
:-//
TheHolyHorse:

--- Quote from: Arjunan M R on June 27, 2019, 09:49:44 am ---
--- Quote from: TheHolyHorse on June 23, 2019, 11:31:42 am ---
--- Quote from: Arjunan M R on June 23, 2019, 11:22:37 am --- Then what is the best way to add current limiting?

--- End quote ---

Mine is just using some mosfet as pass transistor. It's basically doing what the voltage regulator is doing internally.

--- End quote ---
:-//

--- End quote ---

Oh well I just meant that I used mosfets instead of volt regs.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod