Electronics > Beginners

How to add soft-start feature to a PSU?

<< < (11/13) > >>

TheHolyHorse:

--- Quote from: Arjunan M R on June 23, 2019, 12:30:22 pm ---
--- Quote from: TheHolyHorse on June 23, 2019, 12:06:38 pm ---
--- Quote from: Arjunan M R on June 23, 2019, 12:00:02 pm ---Here is mine.

--- End quote ---

BTW if you're making your own symbols and footprints save them in a project specific library and include that library with the project files. RN some symbols are missing.

--- End quote ---
Sorry.I didn't save it into project specific library.What can I do.
Are you having problems with footprints.

--- End quote ---

Not the footprints only library symbols not showing up.

Arjunan M R:
 After looking at your  schematic it turns out that you are doing I limiting as i am doing :-//

TheHolyHorse:
Yes

Arjunan M R:

--- Quote from: TheHolyHorse on June 23, 2019, 11:31:42 am ---
--- Quote from: Arjunan M R on June 23, 2019, 11:22:37 am --- Then what is the best way to add current limiting?

--- End quote ---

Mine is just using some mosfet as pass transistor. It's basically doing what the voltage regulator is doing internally.

--- End quote ---
:-//

TheHolyHorse:

--- Quote from: Arjunan M R on June 27, 2019, 09:49:44 am ---
--- Quote from: TheHolyHorse on June 23, 2019, 11:31:42 am ---
--- Quote from: Arjunan M R on June 23, 2019, 11:22:37 am --- Then what is the best way to add current limiting?

--- End quote ---

Mine is just using some mosfet as pass transistor. It's basically doing what the voltage regulator is doing internally.

--- End quote ---
:-//

--- End quote ---

Oh well I just meant that I used mosfets instead of volt regs.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod