Electronics > Beginners

How to add soft-start feature to a PSU?

(1/13) > >>

Arjunan M R:
I am designing a 18V 1A linear PSU.
How can I add soft-start feature to it?
Which needs a slew rate of 18V/100ms or higher upto 500ms?

Here's the schematic of the psu.

TheHolyHorse:
I think you'll need to upload new images with higher resolution, you can't really make out any of it.  :)

Arjunan M R:

--- Quote from: TheHolyHorse on June 22, 2019, 02:16:46 pm ---I think you'll need to upload new images with higher resolution, you can't really make out any of it.  :)

--- End quote ---
i kow that but  I also uploaded the pdf version.

Arjunan M R:

--- Quote from: TheHolyHorse on June 22, 2019, 02:16:46 pm ---I think you'll need to upload new images with higher resolution, you can't really make out any of it.  :)

--- End quote ---
Welcome to the EEVblog Forum ;)

Arjunan M R:
Click on that prescicion bench power supply.pdf

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod