Electronics > Beginners

How to debug a USB 3 connection?

<< < (3/5) > >>

jismal:
Why different part name in schematic and BOM. Those two are different connectors

wraper:
Hmm, probably connector is not properly soldered because I don't see 2 holes for plastic guides. EDIT: different connector used on PCB

wraper:

--- Quote from: jismal on December 02, 2018, 01:28:47 am ---Why different part name in schematic and BOM. Those two are different connectors

--- End quote ---
Now I see why there are no holes for plastic guides and 2 additional holes present. Connector is different. That was misleading.

Jackster:
I believe the schematic parts are just mislabelled.

jismal:
Just posting though
Ti recommendation for SuperSpeed Differential Routing
Maximum single differential pair size 8 inches
Maximum mismatch within single pair 5 mils.
Group matching?
Impedance 90ohm +-15%

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod