Electronics > Beginners

How to debug a USB 3 connection?

<< < (5/5)

wraper:
And it would be better to not have GND fills at all at outer layers rather than having them located inconsistently around diff pairs, thus inconsistently affecting impedance.

dmills:
That board does have a buried ground plane right? If not I think you have diff pairs crossing reference planes in a few places, never a good look at these speeds.

Regards, Dan.

wraper:

--- Quote ---Board is 4 layer, the middle 2 are ground only.
--- End quote ---

dmills:

--- Quote from: wraper on December 02, 2018, 01:30:12 pm ---Board is 4 layer, the middle 2 are ground only.

--- End quote ---
Gaa, insufficient caffeine error!

Regards, Dan.

Jackster:
Should I just hire someone from here to start from scratch instead of bothering with this freelancer?

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod