Electronics > Beginners
How to pair a variable gain amplifier to an ADC
(1/2) > >>
whatsthegeek:
Hi, I'm currently designing my own Software Defined Radio. I'm already done with most of the front end but now I have to design the ADC and VGA circuit   :-\
I decided to use a LTC2205 ADC and a LT5554 VGA, the specs seem perfect for what I want to do, however, I don't understand a thing to how I'm supposed to pair them up :(

First of all, I need to convert the single ended signal to a differential signal with a bias voltage for the VGA. I know this should be easy to do with a 1:1 transformer with a center tap on the secondary
But here comes the part where I'm lost:

The VGA apparently needs some sort of constant current at the output???? The datasheet says:
"A transformer with a center tap tied to VCC or a choke inductor is recommended to conduct the DC quiescent current"
What does that mean ? |O

Also, the output of the VGA and the input of the ADC don't have the same impedance, how can I match them correctly to get the best results possible?

And if that wasn't enough, the ADC needs a bias voltage on the input  :palm:
I's also very important that the matching circuit works from as close to DC as possible, to at least 30MHz
I'm pretty much completely lost at this point  :-\

And if you couldn't tell already, I'm a complete n00b at ADCs and RF. It's my first project even with both of these :(


So, could someone help me understand why the VGA needs a bias current and maybe suggest a circuit?

Thanks in advance  ;)

Zero999:
I also have no experience with RF ADCs or VGA circuits, but have quickly read the datasheet for the LT5554.

It's a transconductance amplifier, which means it takes a voltage and converts it into a current. To convert the current into a voltage, a resistor is normally added to the output, but in this case, it has an internal 400R resistor connected across the output.

There's no need to match the impedances, as long as the traces on the PCB are kept short enough. If the the traces between the ADC and VGA are no more than a couple of cm, then it shouln't be a problem.
whatsthegeek:
Thanks for the reply!

So, all I would need to do to connect the LT5554 to the LTC2205 ADC is use two coupling capacitors and a 1:1 transformer with a center tap to bias the input?
Bud:

--- Quote from: Zero999 on October 09, 2019, 02:53:20 pm ---There's no need to match the impedances, as long as the traces on the PCB are kept short enough. If the the traces between the ADC and VGA are no more than a couple of cm, then it shouln't be a problem.

--- End quote ---
This is incorrect, the mismatch will not go anywhere. I would not bother matching 1:1.5 SWR but if it is like 50 Ohm one stage and 200 Ohm the other stage that have to be matched.
whatsthegeek:
Yikes this stuff is hard   :-\

If I understand the datasheet of the ADC (which I'm not 100% sure I am), the manufacturer recommends a 50Ohm impedance but they don't say what the impedance of the ADC is.

and, in the datasheet of the VGA, they say that output impedance affects the gain and SNR, so I better get it right  :-\

I'm even more lost at this point  |O
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod