Electronics > Beginners
How to wire a Current Transformer
(1/1)
anishkgt:
Hi All,

Is there anything else that i would need when using a Current Transformer ? I will be using this with an arduino to measure AC current of a Spot welder. The current schematic of the Current Transformer is from its data sheet (http://www.tamuracorp.com/clientuploads/pdfs/engineeringdocs/L06PXXXS05.pdf)

The optocoupler is to sense when the electrodes are shorted for a spot weld.
Dave:
That is not a current transformer, but rather a hall effect current sensor. Yes, your connection method is correct.
anishkgt:
Thank you appreciate it.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod