Electronics > Beginners
How to work with SPI on arduino and the STP16CP05 LED driver
(1/1)
Se3ker:
Hi,

im trying to get this https://www.st.com/resource/en/datasheet/stp16cp05.pdf LED driver to work with Arduino.
I've read about SPI but I don't understand it yet.

I hooked up the LED driver to the Arduino Nano like this:

1-GND -> GND
24-VDD -> +5V
2-SDI  ->  D11(MOSI)
3-CLK -> D13(SCK)
4-LE/DM1 -> D8
23-R-EXT -> 1K resistor -> GND
22-SDO -> not connected
21-OE/DM2 -> D10(PWM)

I also put 16 LEDs anode to +5V and cathode to OUT0-OUT15

Is this is the correct hookup?
Can anyone please help me with Arduino code for blinking these LEDs?

Thanks.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod