| Electronics > Beginners |
| I keep killing mosfets - what I do wrong? |
| << < (6/6) |
| iMo:
--- Quote from: PMA on September 29, 2019, 08:05:20 am ---That is a good advice. However, the problem is already solved. My soldering iron was in ungrounded outlet which caused large potential difference between grounded PCB and tip of the iron. --- End quote --- Long time back the mosfets (no esd diodes at that time on the chip) had the legs shorted by a piece of copper wire (a small spring actually). In harsh environment simply wind a thin wire around the legs and solder the transistor in. After soldering remove the wire. |
| Yansi:
That is unfortunately not that easy when soldering today's surface mount devices. :-/O |
| Navigation |
| Message Index |
| Previous page |