Electronics > Beginners
Identifying SMD components
<< < (3/3)
Alex Trofimov:
I ususally type in google "xxx smd marking", where xxx is the code. If you are uncertain in some characters try every variant. I had pretty decent luck this way)
flasonsmts:
Normally the pick and place machine need mark point for each SMD component to identity the position. You said the SMD don't have name on it, I think it''s Can't identify by pick and place machine. The name on the SMD surface not only just a name, it also tell pick and place machine the current direction of the SMD.  The solutions for your SMD is to test each SMD direction and print name on it.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod