Electronics > Beginners

Input Attenuator

(1/1)

timj:
Hello, I'm a beginner in electronics. I've been tasked with a practical that I've attached on here. To my understanding this is just a simple voltage divider. As it states, I need to modify the circuit such that the output is half the input AC signal. The audio generator that I have has an output of 600 ohm. Would I just include that in the voltage divider rule V_out = (R2/R1+R2) x V_in? And then change either R1 or R2 until I get the half the input signal?

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod