Electronics > Beginners
Is there a way to make a cheap multimeter into a contactless amp meter?
drussell:
--- Quote from: Giaime on August 02, 2018, 07:22:43 am ---When trying to insert the clamp into a tight distribution panel you can touch by mistake some live wires...
--- End quote ---
Who said he wanted to probe distribution panels with his homemade current meter? :)
lordvader88:
I have generic Hall effect sensors, I haven't had time to try them at all yet. I want to make a non-contact current probe and see how well it works.
I figured that would be easier/less expensive than trying to make a clamp meter that uses really fine wire coil.
iainwhite:
--- Quote from: drussell on August 02, 2018, 03:24:32 pm ---Who said he wanted to probe distribution panels with his homemade current meter? :)
--- End quote ---
Who assumed OP was male? :)
Beamin:
I wouldn't trust my life or risk fire to any DIY, or Chinese/ebay device for that matter, but I was thinking some type of resistor voltage divider set up where you can move a decimal point visually and get a reading on a DC source without cutting wires. Maybe I should study ohms law a bit more.
Karlo_Moharic:
You can buy add-on clamps so yes , I guess , depending what your definition of cheap is
Navigation
[0] Message Index
[*] Previous page
Go to full version