EEVblog Electronics Community Forum

Electronics => Beginners => Topic started by: jpyeron on November 24, 2019, 04:06:05 am

Title: learning how to use my Rigol DS1104Z's features, need help
Post by: jpyeron on November 24, 2019, 04:06:05 am
I am trying to reverse engineer a communications protocol between two black boxes.

The reader has an inductive coil and the sensor has a mating coil. I have put a man in the middle coil circuit, and the reader communicates with the sensor successfully.

It appears as a 7kHz 34V peak to peak sine wave, sampled as show here: [attach=1]. The communications start after pressing the trigger and last less than 5 seconds (having trouble getting an exact timing).

I tried the record feature, but captures way too little (2 frames), so I know I am doing something wrong.

Title: Re: learning how to use my Rigol DS1104Z's features, need help
Post by: jpyeron on November 24, 2019, 05:12:04 am
I am assuming that I will see something like: [attachimg=1].

I am looking to trigger continuous recording, until memory is exhausted and after the first trigger event.

The whole signal is about a second long.

100us per div https://youtu.be/at8rgkf5-hs?t=4 (https://youtu.be/at8rgkf5-hs?t=4)

20us per div https://youtu.be/at8rgkf5-hs?t=17 (https://youtu.be/at8rgkf5-hs?t=17)
Title: Re: learning how to use my Rigol DS1104Z's features, need help
Post by: jpyeron on November 24, 2019, 05:56:44 pm
Solved it - Roll mode - page 63 of the manual