| Electronics > Beginners |
| learning how to use my Rigol DS1104Z's features, need help |
| (1/1) |
| jpyeron:
I am trying to reverse engineer a communications protocol between two black boxes. The reader has an inductive coil and the sensor has a mating coil. I have put a man in the middle coil circuit, and the reader communicates with the sensor successfully. It appears as a 7kHz 34V peak to peak sine wave, sampled as show here: . The communications start after pressing the trigger and last less than 5 seconds (having trouble getting an exact timing). I tried the record feature, but captures way too little (2 frames), so I know I am doing something wrong. |
| jpyeron:
I am assuming that I will see something like: . I am looking to trigger continuous recording, until memory is exhausted and after the first trigger event. The whole signal is about a second long. 100us per div https://youtu.be/at8rgkf5-hs?t=4 20us per div https://youtu.be/at8rgkf5-hs?t=17 |
| jpyeron:
Solved it - Roll mode - page 63 of the manual |
| Navigation |
| Message Index |