EEVblog Electronics Community Forum
Electronics => Beginners => Topic started by: nikodem on September 12, 2020, 07:25:44 pm
-
I'm trying to understand how to interface this linear CCD to an e.g. Arduino.
This is the timing chart of the interface:
(https://obrazki.elektroda.pl/5944738900_1599936561_bigthumb.jpg) (https://obrazki.elektroda.pl/5944738900_1599936561.png)
Nowhere I can find any information how to control the exposure time. Is TG responsible for that?
Regarding the read - I clock the pixels with 1 and 2 clocks (sort of differentially), latch it with RB tied to CLB and then put SHB low, so I can read the Vout?
:scared: