Electronics > Beginners
Linear Technology LT1963 1.5A LDO - Output current no more than 100mA!
<< < (5/6) > >>
Psi:
I call more breadboard shenanigans going on
hgg:
Hmm, ok, I think I will wait for the 3M breadboard to arrive and continue from there...
I am also going to buy this one as well from TME :

WISHER ENTERPRISE WBU-204-1
https://www.tme.eu/gr/en/details/wbu-204-1/universal-pcbs/wisher-enterprise/

I've read that they are good as well.
bd139:
Both are good. I have wisher and 3m boards.

However I would solder something up for this sort of test on a bit of FR4.
hgg:
Good to know.
I don't have a desoldering gun and these multiple pin connectors are a bugger to desolder!
I might try it though because this problem is really strange even with these wicked breadboards.
Maybe I will solder them higher from the board and when I finish, cut them.
bd139:
If I'm doing prototyping with the SMD adapter boards, I usually use a piece of FR4 as a ground plane, don't use the pins, glue the SMD adapters down with hot snot and then wire them direct with 1/0.6 wire. I also got some SMD prototype boards made up which make this stuff a lot easier:



(unfortunately i cant find the gerbers I used otherwise I'd post them here)

Quick fugly example. RC filter to get rid of some noise in something.

Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod