Electronics > Beginners

Linear Technology LT1963 1.5A LDO - Output current no more than 100mA!

<< < (5/6) > >>

Psi:
I call more breadboard shenanigans going on

hgg:
Hmm, ok, I think I will wait for the 3M breadboard to arrive and continue from there...
I am also going to buy this one as well from TME :

WISHER ENTERPRISE WBU-204-1
https://www.tme.eu/gr/en/details/wbu-204-1/universal-pcbs/wisher-enterprise/

I've read that they are good as well.

bd139:
Both are good. I have wisher and 3m boards.

However I would solder something up for this sort of test on a bit of FR4.

hgg:
Good to know.
I don't have a desoldering gun and these multiple pin connectors are a bugger to desolder!
I might try it though because this problem is really strange even with these wicked breadboards.
Maybe I will solder them higher from the board and when I finish, cut them.

bd139:
If I'm doing prototyping with the SMD adapter boards, I usually use a piece of FR4 as a ground plane, don't use the pins, glue the SMD adapters down with hot snot and then wire them direct with 1/0.6 wire. I also got some SMD prototype boards made up which make this stuff a lot easier:



(unfortunately i cant find the gerbers I used otherwise I'd post them here)

Quick fugly example. RC filter to get rid of some noise in something.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod