Electronics > Beginners
LiPo not charging using MCP73831
<< < (3/3)
joeyjoejoe:
In this case it's a PCB, so no manual wiring :)

A head scratcher for sure.
Kasper:
3.8V is probably low enough. You could drain it to about 3.4V to be sure.

If you post pictures of the PCB that might help.
joeyjoejoe:
Follow up - ghost in the machine.

I got the replacement today and popped it on the PCB. Drawing almost 500mA now from USB :)

@KL27x, I'm thinking maybe I had the wrong version as you suggest.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod