Electronics > Beginners

Logging a voltage and a current in the same time

(1/3) > >>

AlexResch:
I would like to log a voltage ( 6.3V ) and a current ( 150mA) in the same time and then use the table to build a graph. Is there a multimeter which can do that at some chosen frequency ( aprox 3-5 times/second ).

KE5FX:

--- Quote from: AlexResch on September 06, 2018, 09:45:36 am ---I would like to log a voltage ( 6.3V ) and a current ( 150mA) in the same time and then use the table to build a graph. Is there a multimeter which can do that at some chosen frequency ( aprox 3-5 times/second ).

--- End quote ---

The Mooshimeter might be a good option for you.  They are quite handy.

RoGeorge:
Metrix MTX3283 DMM can log V and I in the same time (3 wires only), fastest sample rate is 1 measurement/second, and the maximum length is about 3000 measurements. The log is kept inside the DMM, so it can log without a PC.

joeqsmith:
Five samples/second with V/I may be an expensive meter.   You may be better off with a cheap microcontroller evaluation board with a decent ADC. 

There is always the Analog Devices, or in my case I have a Labjack. 

JS:
121GW?

JS

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod