Electronics > Beginners
Looking for wired+wireless mesh network
(1/1)
SimonST:
Hi All!
Trying to expand a project, and looking for how to do communication...
I would like to use a both wires and wireless links to connect many Slaves to a Master for a project. I was thinking about 802.15.4, Zigbee or similar, but that is wireless only. I would like to be able to connect slaves with wires when possible and use wireless hops when not possible. Does anyone know of some existing solution/communication protocol that does this. I would like it to not require any user interaction to change between wire and wireless, I would like it to mesh over whatever exists.
Aiming for cables max length of 1000m (thinking RS485 style) and wireless hops of max 1000-3000m. Low speed requirements. About max 50 kbits/s.
Any ideas?
german77:
Take a look on CAN bus. They are used on PLC in industries and cars to read from many sensors and control many actuators in a master slave configuration.
Switching between wireless and wired transparently I can only think of Ethernet 802.3 with is the way Internet it's connected.
SimonST:
Thanks, I have been considering CAN for the wired bus but any mesh solution would be more nice.
Navigation
[0] Message Index
Go to full version