Electronics > Beginners

Lorton cap ck w/Siglent 1052, pictures and video

(1/1)

billbyrd1945:
Wanted to see if my super cheap signal generator and my Siglent SDS1052DL+ would suffice to do the o'scope cap check featured in this video:



I was able to get a nice waveform but couldn't get the math to work out. I have no problem whatsoever in accepting that I simply can't deal with that many zeros and conversions. If you'd like to try, here's the setup I used if you'd like to give it a try: Hertz jumper: max; all knobs centered; resistor: 22k; cap: 4.7uF. Images attached.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod