Electronics > Beginners
High Side MOSFET Check
<< < (3/3)
joeyjoejoe:
Can I use something like 100k for R1 to keep the current negligible when enabled (and reduce BOM count as I'm using 100k's in a few places for pullups)

langwadt:
simple easy safe solution is using an USB supply switch like e.g. http://www.ti.com/lit/ds/symlink/tps25221.pdf
MarkF:
Here is a circuit I found some time back for a solar panel charge controller doing a similar thing

   
joeyjoejoe:
@bson, thanks again. I've contributed the DMC2053UVT to the official KiCad repository :)

Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod