Electronics > Beginners

LSM9DS1 - Pull-up resistor on INT?

(1/1)

Tantalum:
Hello

Can someone confirm that there is no need for a pull-up resistor on the 3 INT (INT1_A/G, INT2_A/G, INT_M) pin of the LSM9DS1 IMU?
It's not indicated if it's open-drain or not.
https://www.st.com/resource/en/datasheet/lsm9ds1.pdf

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod