EEVblog Electronics Community Forum
Electronics => Beginners => Topic started by: Griffin on May 14, 2012, 12:58:04 pm
-
Hi every1
I am building a fan control circuit based on the one form this link: http://extremeelectronics.co.in/avr-projects/avr-project-remote-controlled-fan-regulator/ (http://extremeelectronics.co.in/avr-projects/avr-project-remote-controlled-fan-regulator/) to learn more about optocouplers. My problem is it uses a MCT2E optocoupler that is not available from RS Components or digi-key in our country. Is there a spec similar optocoupler I can use that will do the same job?
Thanks for the help.
-
From the looks of the schematic none of the parameters for the part are too critical. You just need to find an optocoupler in the same package (6-pin DIP, 0.300" lead spacing) with the same pinout. That's a pretty standard pinout.
Any of the following from the "4N" series optocouplers should work: 4N25 thru 2N28 or 4N35 thru 4N37. These are very common.
-
So far it looks good but will studdy the datasheets to make sure. Thanks allot.