Electronics > Beginners
MESR 100 v2 leads
(1/2) > >>
Noidzoid:
Hello one and all
Could someone tell me why the leads that came with this meter are so short (I'm assuming there is a reason), and is there any reason why I shouldn't change them for something longer with probes on the end rather than the cumbersome alligator clips that are difficult to use in small spaces.
Sorry if this is a dumb question but I really am quite new to this.
Many thanks in advance to anyone shedding light on this.
wraper:
You'll get more error in readings with long leads. Also if you use long leads, both of them should be attached together to basically make a single cable, otherwise readings will significantly vary depending on the cable position because of series inductance change.
Noidzoid:
Thanks for the reply Wraper.
Do you mean the wires should be taped/twisted together so they are close to each other but not actually connected (core to core)?  If this is the case I will make up a new set. One of the reasons I bought this unit was that I thought it could be used to test capacitors without having to remove them from the board, but the short length and awkward clips don't make it easy.
wraper:
You could tape them together at say each 10 cm of distance.
Noidzoid:

--- Quote from: wraper on June 21, 2018, 08:41:37 am ---You could tape them together at say each 10 cm of distance.

--- End quote ---

Many thanks Wraper much appreciated
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod