Electronics > Beginners
Mimicking a cluster (car dash) circuit to allow for fuel measurement.
(1/1)
zoloft_:
Hi,
In an effort to convert my car's cluster to an arduino controlled system I have run into a problem reverse engineering the fuel level circuit. On first glance it seems to be a simple series? circuit that measures the voltage drop across the fuel sensor to get the data, however when the circuit is probed, pin 5 (highlighted in green) is connected to ground while pin 6 (highlighted in red) reads a voltage between 1 and 8 volts. The fuel level is read by the PCM by connection at two points (highlighted in blue). If a voltage between 1-8 volts is applied to pin 6 (with the cluster disconnected) the fuel level read by the control module can be manipulated and is directly correlated to the voltage applied. Is there any way I could bypass the cluster to allow for the PCM to read the data in its absence? Perhaps I am likely misinterpreting the circuit as I am new to electrical work. Thanks for the help and any additional wiring diagrams or measurements will be provided as soon as requested.

Lily

Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod