Electronics > Beginners
Mini TS100 soldering iron and current leakage
<< < (11/14) > >>
wraper:
BTW I don't see claimed resistor on the schematic on it's front panel.




stj:
that's just a sketch - post a photo of the base pcb.
wraper:

--- Quote from: stj on June 29, 2017, 05:46:55 pm ---that's just a sketch - post a photo of the base pcb.

--- End quote ---
Whaat? Burden of proof is on the claiming side (you claimed there is a resistor). Where should I get that outdated station in the first place, LOL? Have you even measured a resistance between the earth connection and the tip?
stj:
yes, i did.
it had a resistor and rifa capacitor in parallel FYI.

still, it's history now - those are on my parts shelf with no electronics in them.
i was thinking of fitting a digital controller and ssr in them to use a newer iron assembly.
KL27x:
@stj thx for the link. That helps. If im reading it right, there are only 3 connections on the cartridge, then. And the ts100 only uses 2 or them, no connection the to tip/sheath. So no hidden metal contact on the very back end of the cartridge?
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod