Electronics > Beginners
Mini TS100 soldering iron and current leakage
wraper:
BTW I don't see claimed resistor on the schematic on it's front panel.
stj:
that's just a sketch - post a photo of the base pcb.
wraper:
--- Quote from: stj on June 29, 2017, 05:46:55 pm ---that's just a sketch - post a photo of the base pcb.
--- End quote ---
Whaat? Burden of proof is on the claiming side (you claimed there is a resistor). Where should I get that outdated station in the first place, LOL? Have you even measured a resistance between the earth connection and the tip?
stj:
yes, i did.
it had a resistor and rifa capacitor in parallel FYI.
still, it's history now - those are on my parts shelf with no electronics in them.
i was thinking of fitting a digital controller and ssr in them to use a newer iron assembly.
KL27x:
@stj thx for the link. That helps. If im reading it right, there are only 3 connections on the cartridge, then. And the ts100 only uses 2 or them, no connection the to tip/sheath. So no hidden metal contact on the very back end of the cartridge?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version