| Electronics > Beginners |
| Modern oscilloscope views: YT, XY but where is XYZ ? |
| << < (5/6) > >> |
| stj:
yes, i asked because you dont really see the screen refresh rates mentioned with reasonable priced scopes like Rigol, Siglent or GW-Instek. |
| Ivan7enych:
Sorry, I raise up this old thread. I just found undocumented XYZ mode in my Agilent MSOX3000! This oscilloscope has XY mode and locks X to channel 1 and Y to channel 2, but if you put any signal to Trigger Input - it will work as bynary Z input! I've found this accidentally, wondering why I see only half of XY picture, when signal generator Trigger Out was connected to oscilloscope Trigger In. Here it is seen in my video (in russian). 0:40 - I disconnect Trigger Input and half picture become full picture. 1:15 - I connect 3rd generator to Trigger Input |
| mikeselectricstuff:
What would be interesting is a scope that would do XYZ plotted as a 3D image, with the scope controls adjusting the viewpoint. |
| Yansi:
Meow! |
| MarkL:
--- Quote from: Ivan7enych on October 25, 2019, 11:26:52 am ---... I just found undocumented XYZ mode in my Agilent MSOX3000! --- End quote --- Actually, it is in the user manual. It's called "blanking" and has a fixed on/off threshold of 1.4V. |
| Navigation |
| Message Index |
| Next page |
| Previous page |